Polygonal Spiral needs to add rotate parameters
-
@VectorStyler Thank you very, very much. it's even more impressive than I imagined.
-
@VectorStyler During use, it was also found that two options were missing:
-
The corner radius values for polygon spirals lack customization for inside and outside separately;
https://youtu.be/hVoS3urnqLY -
Spiral and polygon spiral need to support custom shapes.
-
-
@Li-Xiao said in Polygonal Spiral needs to add rotate parameters:
Spiral and polygon spiral need to support custom shapes.
it is not clear how this would work for spiral?
-
@VectorStyler If Polygonal Spiral can create elliptical spirals, there is no need to modify Spiral. This feature is commonly used in laser engraving, and there are plugins in CorelDraw that offer this function, but I dislike the subscription model.
-
@Li-Xiao said in Polygonal Spiral needs to add rotate parameters:
and there are plugins in CorelDraw that offer this function,
Send me a link to this.
-
@VectorStyler Offset can solve some problems, but decay doesn't work.
-
@Li-Xiao said in Polygonal Spiral needs to add rotate parameters:
However, the Polygonal Spiral is missing a rotational parameter, and I hope it can be added.
There is a Rotation parameter for the polygonal spiral that can be found in the Shape panel.
-
@VectorStyler I know, this feature was added in version 1.2.020. Thanks again.
-
@Li-Xiao My mistake, I read the original post and did not check the date.
The actual answer should be about the spiraling case: this will require a new shape type. I will try to add this to version 1.3.
-
@VectorStyler Looking forward to the upcoming 1.3 version, thank you very much!
