Skew while in transform tool
-
Is there any option in preference to enable skew in transform tool. Like this in this recording
-
@Jayanta-Das Is 'Rotate with Knob' selected in Prefs > Adjustments > Selection Box?
In the default configuration (Rotate from Corners) skewing an object can be done with the Transform tool (shortcut: V) directly if you place the cursor on the sides, near the handles.
-
@b77 Thanks. Rotate with knob is enabled.
-
@Jayanta-Das The 'Rotate with Knob' option was introduced later at users' request, but I think skewing should be made to work with it as well.
-
@b77 Yes. I like rotating object with knob and also would like to skew at the same time with transform tool.
-
@b77 said in Skew while in transform tool:
The 'Rotate with Knob' option was introduced later at users' request,
This all makes sense now what @Jayanta-Das was requesting. I remember when the knob was requested.
I too, use the "default rotate from corners" myself
-
@Jayanta-Das said in Skew while in transform tool:
Is there any option in preference to enable skew in transform tool. Like this in this recording
In default mode, when hovering slightly outside of the nodes at the center of the edges, the cursor turns into "skew" mode
